CyberData 011214 Especificações descarregar pdf (Página 36)

Installing the VoIP Outdoor Intercom with Keypad

Intercom Setup

Operations Guide 930809M CyberData Corporation

Relay Settings

Activate Relay with DTMF Code Activates the relay when the DTMF Activation Code is entered on the

phone during a SIP call with the device. RFC2833 DTMF payload

types are supported.

DTMF Activation Code

Activation code used to activate the relay when entered on a phone

during a SIP call with the device. Activate Relay with DTMF Code

must be enabled. Enter up to 25 digits 

(* and # are supported).

DTMF Activation Duration (in seconds)

The length of time (in seconds) during which the relay will be

activated when the DTMF Activation Code is detected. Enter up to 5

digits.

NOTE:

A DTMF activation duration of 0 will toggle the relay

indefinitely or until the activation code is sent again

Play tone during DTMF Activation

When selected, the device will play a tone out of the speaker upon

DTMF relay activation. The tone plays for the DTMF Activation

Duration (in seconds).

Activate Relay During Ring

When selected, the relay will be activated for as long as the device is

ringing. When Auto-Answer Incoming Calls is enabled, the device will

not ring and this option does nothing.

Activate Relay During Night Ring

When selected, the relay will be activated as long as the Nightringer

extension is ringing.

Activate Relay While Call Active

When selected, the relay will be activated as long as the SIP call is

active.

Activate Relay on Button Press

When selected, the relay will be activated when the Call button is

pressed.

Relay on Button Press Duration

The length of time (in seconds) during which the relay will be

activated when the Call button is pressed. Enter up to 5 digits. A

Relay on Button Press Duration value of 0 will pulse the relay once

when the Call button is pressed.

Clock Settings

Set Time with NTP Server on boot When selected, the time is set with an external NTP server when the

device restarts.

NTP Server

Use this field to set the address (in IPv4 dotted decimal notation or

as a canonical name) for the NTP Server. This field can accept

canonical names of up to 64 characters in length.

Posix Timezone String

See Section 2.4.5.1, "Time Zone Strings" for information about how

to use the Posix Timezone String to specify time zone and daylight

vings time where applicable. Enter up to 63 characters.

Periodically sync time with server

When selected, the time is periodically updated with the NTP server

at the configured interval below.

Time update period (in hours)

The time interval after which the device will contact the NTP server to

update the time. Enter up to 4 digits.

Current Time Allows you to input the current time

. (6 character limit)

Table 2-7. Device Configuration Parameters (continued)

Web Page Item Description

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 118 119

Comentários a estes Manuais

Sem comentários

CyberData 011214 Especificações Página 36

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de porteiro eletrónico CyberData 011214