CyberData 011214 Especificações descarregar pdf (Página 16)

Installing the VoIP Outdoor Intercom with Keypad

Intercom Setup

Operations Guide 930809M CyberData Corporation

2.3 Intercom Setup

2.3.1 Intercom Connections

Figure 2-3 shows the pin connections on the J3 (terminal block). This terminal block can accept 

16 AWG gauge wire.

Note As an alternative to using PoE power, you can supply 8 to 12 VDC at 100

0 mA into the

terminal block.

GENERAL ALERT

Caution

Equipment Hazard: Contacts 1 and 2 on the J3 terminal block are only for

powering the Intercom from a non-PoE 12 VDC power source as an alternative to

Network PoE power. Use of these contacts for any other purpose will damage the

Intercom and void the product warranty.

Figure 2-3. Intercom Connections

J3 Terminal Block

Wire (IN)

can accept 16 AWG wire

*Contacts 1 and 2 on the J3 terminal block are only for

powering the Intercom from a non-PoE 12VDC power

source as an alternative to Network PoE power. Use of

these contacts for any other purpose will damage the

Intercom and void the product warranty.

Relay Contact:

(1 A at 30 VDC for continuous loads)

3 = Relay Common

4 = Relay Normally Open Contact

5 = Sense Input

6 = Sense Ground

2 = Power Ground*

1 = 8 to 12 VDC at 1000 mA*

Alternate Power Input:

7 = Reserved for Future Use

8 = Reserved for Future Use

Use a 3.17 mm (1/8-inch) flat blade

screwdriver for the terminal block screws

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 118 119

Sem comentários

CyberData 011214 Especificações Página 16