CyberData 011114 Especificações descarregar pdf (Página 22)

Installing the VoIP V2 Loudspeaker Amplifier

Loudspeaker Amplifier Setup

Operations Guide 930375C CyberData Corporation

2.2.7 Confirm the IP Address and Test the Audio

2.2.7.1 RTFM Switch

When the Loudspeaker Amplifier is operational and linked to the network, use the Reset Test

Function Management (RTFM) switch (Figure 2-14) on the Loudspeaker Amplifier face to announce

and confirm the Loudspeaker Amplifier’s IP Addr

ess, and test that the audio is working.

Figure 2-14. RTFM Switch

Announcing the IP

Address

To announce a Loudspeaker Amplifier’s current IP address:

1. Press and hold the RTFM switch until you h

ear the IP address announcement.

2. Release the RTFM switch.

GENERAL ALERT

Caution

Equipment Caution: Pressing and holding the RTFM switch for more than five

seconds after the IP address announcement will restore the V2 Paging Amplifier

to the factory default settings. See the “Restoring the Factory Default Settings”

section.

Restoring the

Factory Default

Settings

To restore the factory default settings, complete the following steps:

1. Press and hold the RTFM switch until you hear the IP a

ddress announcement. Continue holding

the RTFM switch for an additional five seconds until you hear the Paging Amplifier announce

the words, “restoring defaults” and “rebooting”.

2. Release the RTFM switch. The Paging Amplifier will be

restored to the factory default settings.

RTFM switch

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 46 47

Sem comentários

CyberData 011114 Especificações Página 22