CyberData 011114 Especificações descarregar pdf (Página 14)

Installing the VoIP V2 Loudspeaker Amplifier

Loudspeaker Amplifier Setup

Operations Guide 930375C CyberData Corporation

2.2.1 Loudspeaker Amplifier Components

Figure 2-3 shows the components of the Loudspeaker Amplifier .

Figure 2-3. Loudspeaker Amplifier Components

DIP Switches

Speaker Volume

Network Link LED (GREEN/YELLOW)

Status LED (GREEN)

A steady LED confirms that the Loudspeaker Amplifier is oper-

ational. The LED will blink during a page when it is online.

Network Activity LED (GREEN)

Power LED (GREEN/BLUE)

The power LED is a steady green in low power mode and

a steady blue during high power mode. The power LED

will only blink either during a boot up or a phone call.

RTFM Switch

To broadcast a Loudspeaker Amplifier’s current IP

address, press and hold the RTFM switch until you hear

the IP address announcement, and then release the

RTFM switch.

To restore the factory defaults, complete the following

steps:

1. Press and hold the RTFM switch until you hear the IP

address announcement. Continue holding the RTFM

switch for an additional five seconds until you hear the

Loudspeaker Amplifier announce the words, “restoring

defaults” and “rebooting”.

2. Release the RTFM switch. The Loudspeaker Amplifier

will be restored to the factory default settings.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 46 47

Sem comentários

CyberData 011114 Especificações Página 14