CyberData 011280 Especificações descarregar pdf (Página 25)

Installing the Singlewire Paging Adapter

Configure the Device Parameters

Operations Guide 930729A CyberData Corporation

2. On the Device Configuration page, you may enter values for the parameters indicated in

Ta b l e 2-6.

3. After changing the parameters, click the Sa

ve button.

Table 2-6. Device Configuration Parameters

Web Page Item

Description

Miscellaneous Settings

Beep on Initialization When selected, you will hear a beep when the device initializes.

Enable line in to line out

loop

back

When selected, audio is sent from the line -in to the line-out output.

Enable relay on local audio When selected, the relay will be closed any time that audio is played

ut of the line-out/page port. This setting is for legacy analog

amplifiers that are often connected to the page port. Analog amplifiers

will often have a noticeable hum if they are turned on while there is no

audio being played. The relay closure causes these amplifiers to turn

on only when audio is sent to them.

Click the Save button to save your configuration settings.

Note: You need to reboot for changes to take effect.

When the Test Audio button is pressed, you will hear a voice

message for testing the device audio quality and volume.

Click on the Test Relay button to do a relay test.

Click on the Reboot button to reboot the system.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 44 45

Sem comentários

CyberData 011280 Especificações Página 25