CyberData 011209 Especificações descarregar pdf (Página 19)

Installing the VoIP V3 Emergency Intercom

Intercom Connections

Operations Guide 930504F CyberData Corporation

2.10 Intercom Setup

2.10.1 Intercom Connections

Figure 2-9 shows the pin connections on the J3 (terminal block). This terminal block can accept 

16 AWG gauge wire.

Note As an alternative to using PoE power, you can supply +12 to 24 VDC at 1000 mA (500 mA

minimum) into the terminal block.

GENERAL ALERT

Equipment Hazard: Contacts 1 and 2 on the J3 terminal block are only for

powering the Intercom from a non-PoE +12VDC power source as an alternative to

Network PoE power. Use of these contacts for any other purpose will damage the

Intercom and void the product warranty.

Figure 2-9. Intercom Connections

Caution

J3 Terminal Block

Wire (IN)

Terminal Block

can accept

16 AWG wire

Relay Contact:

(1A at 30 VDC for continuous loads)

3 = Normally Open Common

4 = Normally Open Contact

5 = Door Sense Input

6 = Door Sense Ground Reference

2 = Power Ground*

1 = +12 to 24 VDC at 1000 mA (500 mA minimum)*

Alternate Power Input:

*Contacts 1 and 2 on the J3 terminal block are only for

powering the Intercom from a non-PoE +12VDC power

source as an alternative to Network PoE power. Use of

these contacts for any other purpose will damage the

Intercom and void the product warranty.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 85 86

Sem comentários

CyberData 011209 Especificações Página 19