CyberData 010935 Especificações descarregar pdf (Página 21)

Installing the VoIP Intercom

Intercom Setup

Operations Guide 930181E CyberData Corporation

2.2.6 RTFM Switch Jumper

When the Intercom is operational and linked to the network, use the Reset Test Function

Management (RTFM) switch (see

Figure 2-12) on the Intercom board to announce and confirm the

Intercom’s IP Address, test that the audio is working, and check the volume.

Note You must do this test prior to final assembly. Please remember to remove the RTFM switch

jumper prior to final assembly.

Figure 2-12. RTFM Switch Jumper

2.2.6.1 Announcing the IP Address

To announce an Intercom’s current IP address:

1. Unplug the intercom.

2. Install the RTFM jumper.

3. Plug the network cable into the intercom to supply power to the intercom. The LED will

illuminate during initialization, blink once, and then turn off.

4. The intercom will announce the IP address.

Note If you installed the RTFM jumper, and if you press the Call button for 10 seconds, the

default factory settings will be restored.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Sem comentários

CyberData 010935 Especificações Página 21