CyberData 011097 Especificações descarregar pdf (Página 47)

Installing the VoIP V2 Loudspeaker Amplifier

Configure the Loudspeaker Amplifier Parameters

Operations Guide 930362E CyberData Corporation

On the Audio Configuration page, enter values for the parameters indicated in Tabl e 2-17.

Note Each entry on the Audio Configuration page replaces one of the stock audio files on the

board. When the input box displays the word default, the Loudspeaker Amplifier is using

the stock audio file. If that file is replaced with a user file, it will display the uploaded

filename.

Table 2-17. Audio Configuration Parameters

Web Page Item Description

Audio Files

0-9 The name of the audio configuration option is the same as the spoken

audio that plays on the board (24 character limit).

'0' corresponds to the spoken word “zero.”

'1' corresponds to the spoken word “one.”

'2' corresponds to the spoken word “two.”

'3' corresponds to the spoken word “three.”

'4' corresponds to the spoken word “four.”

'5' corresponds to the spoken word “five.”

'6' corresponds to the spoken word “six.”

'7' corresponds to the spoken word “seven.”

'8' corresponds to the spoken word “eight.”

'9' corresponds to the spoken word “nine.”

Dot Corresponds to the spoken word “dot.” (24 character limit)

Audiotest Corresponds to the message “This is the CyberData IP speaker test

message...” (24 character limit)

Pagetone Corresponds to a simple tone that is unused by default (24 character limit).

Your IP Address is Corresponds to the message “Your IP address is...” (24 character limit).

Rebooting Corresponds to the spoken word “Rebooting” (24 character limit).

Restoring default Corresponds to the message “Restoring default” (24 character limit).

Ringback Tone Corresponds to the ringback tone that plays when calling a remote

extension (24 character limit).

Ring Tone Corresponds to the tone that plays when set to ring when receiving a call

(24 character limit).

Sensor Triggered Corresponds to the sensor when it is triggered (24 character limit).

Night Ring Specifies the ringtone for Night Ringer. By default this parameter uses the

same audio file that is selected for the Ring Tone parameter.

The Browse button will allow you to navigate to and select an audio file.

The Play button will play that audio file.

The Delete button will delete any user uploaded audio and restore the

stock audio file.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 72 73

Sem comentários

CyberData 011097 Especificações Página 47